← All work

Techno-economic analysis

Choosing the product strategy before committing to tooling

Barros & Moreira had to decide how a new range of flushing valves would cover its market: two dedicated valves, one for concealed (in-wall) cisterns and one universal, or a single versatile valve made in versions for both. We compared the two routes on components, material, unit cost and tooling investment, before any mould was committed.

The challenge

Each route had a cost the other avoided. Two dedicated valves keep each product lean and cheap to make, but mean two product lines to tool, stock and assemble. A single valve in versions means one platform to develop and produce, but every unit carries the complexity needed for both markets. Choosing wrong would be expensive to undo once moulds were paid for, so the call had to be made early, on evidence.

What we did

  • Analysed competitor products alongside the candidate designs: components, material and performance in a standard test cistern.
  • Turned each design into a unit cost and a mould investment, on the same basis for all four valves, so the two routes compared like for like.
  • Set both routes side by side in a SWOT, to weigh what the numbers miss: flexibility, development risk, logistics and market coverage.

Approach

1. Technical benchmark

We analysed competitor products alongside the candidate designs, comparing their components, the material each one uses and how they perform in a standard test cistern. That gave the four valves, two per route, a common technical baseline.

2. Economic benchmark

We turned each design into a unit cost and estimated the mould investment each valve needs, on the same basis for all four. The two-product range came out ahead on every line: fewer parts, less material, a lower unit cost in both markets and less tooling per valve.

Two-product rangeSingle flexible product
Market needConcealedUniversalConcealedUniversal
Components (index)100153188253
Part weight (index)100146199227
Unit cost (index)100210201317
Tooling (index)100159172224
How to read it: each column is one valve, grouped by route. Every row is indexed to the lowest valve, the concealed valve of the two-product range (= 100); absolute figures are withheld for confidentiality. Tooling is each valve's own mould investment.

3. SWOT

Finally we set the single-valve route against the two-product range in a SWOT, to weigh what the numbers miss.

Strengths

  • One valve for concealed and universal cisterns
  • Components shared across both versions
  • Precise regulation in a compact body
  • Modular, ready for new ways to actuate it

Weaknesses

  • More parts
  • A more complex assembly line
  • Higher unit cost, especially for concealed cisterns
  • More quality control in production

Opportunities

  • More automated assembly
  • Fewer moulds and simpler logistics
  • Certification to several standards
  • Partnerships with sanitaryware makers and builders

Threats

  • A longer, less certain development
  • Higher cost squeezing margins or price
  • No low-cost product for less demanding markets
SWOT of the single-valve route, set against the two-product range.

Outcome

The comparison let Barros & Moreira settle the range strategy early, on evidence and before committing to moulds. It chose the two-product route: a dedicated valve for concealed cisterns and another for the universal market, both now in development with us. Setting component count, material, unit cost and tooling side by side turned a judgement call into an explicit trade-off: leaner, cheaper valves on one side, one shared platform on the other.

Related work · Barros & MoreiraEngineering a dual-flush valve from first principlesThe engineering side of the same range: how its concealed-cistern valve was modelled, prototyped and tested.Read case study

Facing a similar challenge?

A first conversation takes about 30 minutes and costs nothing.